User`s guide

www.bissell.com
7
Operations
Getting ready continued
2. Fill the water tank
A. Remove tank by lifting straight up
and away from unit.
B. Unscrew cap at bottom of water tank
and remove the insert assembly.
C.
Fill water tank with water. For best results,
water should be at room temperature.
D. Replace insert assembly and cap,
tighten until snug.
E. Replace water tank by lining up
vertical guides and gently sliding tank
into place.
3. Twist the quick release cord wrap
clockwise to unwrap the power cord
completely and plug into a 1 proper
outlet as described on the Important
Safety Instructions, page 3.
4.
The ready light will illuminate when the Healthy
Home Steam Mop Max is ready for use.
Before you clean
Thoroughly sweep or vacuum floor prior to cleaning
with the Healthy Home Steam Mop Max.
Cleaning hard floors
Your Healthy Home Steam Mop Max is designed to clean hard
flooring such as ceramic tile, vinyl, laminate, marble, stone and
sealed hard wood floors. Use of your Healthy Home Steam
Mop Max on waxed or some unwaxed floors may result in a
diminished glossiness. The Healthy Home Steam Mop Max is
not for use on unsealed wood floors. For best results test in an
inconspicuous area and check the care instructions from your
flooring manufacturer.
IMPORTANT: Sanitizing on timber floors is not recommended,
as prolonged application of steam in one area increases the risk
of damage to the surface treatment on timber floors, especially
in areas with regular foot traffic and direct sunlight, which will
wear down timber floor surface treatments, making it more
susceptible to steam damage. See Caution to the right.
1. When the ready light illuminates, begin
cleaning by slowly passing over surface
while pressing the steam on demand trigger
to emit steam as needed.
NOTE: The trigger does not need to be
depressed at all times for Healthy Home
Steam Mop Max to work satisfactorly
2A
2B
2E
CAUTION:
The Healthy Home Steam Mop
Max generates hot steam, so
when depressing the trigger to
apply steam, ensure the Healthy
Home Steam Mop Max is mov-
ing continuously. Prolonged
application of steam in one area
increases the risk of damage to
the surface treatment of timber
floors. Exercise extreme care when
using the Steam Mop Max on
timber flooring. Ensure the Steam
Mop Max is thoroughly tested in
an inconspicuous area prior to
mopping a large floor area. The
Steam Mop Max generates hot
steam, so when depressing the
trigger to apply steam, ensure the
Steam Mop is moving continu-
ously. The trigger does not need to
be depressed at all times. Check
with your timber floor treatment
application specialist prior to
Steam Mop Max operation.
WARNING:
Never put descaling, aromatic,
alcoholic, or detergent products
into the steam cleaner, as this
may damage it or make it
unsafe for use.