User Manual

GETTING STARTED

PLEASE READ THIS MANUAL CAREFULLY BEFORE USING THE EZ LOADER. The safety of all persons installing,

using or servicing the EZ Loader is of utmost importance to Bishamon. The EZ Loader is capable of supporting heavy

loads and is capable of causing SEVERE PERSONAL INJURY if used improperly or if certain safety precautions are

not taken. When properly used and maintained, the EZ Loader will provide many years of safe, trouble free service.

If you have any questions about any of the instructions in this manual or about the use of this product, PLEASE

contact your DEALER or Bishamon Industries Corporation.

INSPECTION

IMMEDIATELY upon receipt of the EZ Loader, remove all packing and strapping material and visually inspect the

unit for damage. Any damage to the unit MUST BE NOTED on the delivery receipt. After the preliminary inspection

is conducted, the unit should be thoroughly inspected for any concealed damage that was not readily apparent

during the preliminary inspection. Any concealed damage found that was not noted on the delivery receipt should be

IMMEDIATELY reported in writing TO THE DELIVERING CARRIER.

SAFETY DEFINITIONS

Bishamon uses the following system to identify the degree of risk associated with hazards and unsafe practices.

WARNING - Hazard or unsafe practice which, if not avoided, could result in DEATH or SEVERE

PERSONAL INJURY

and PROPERTY DAMAGE.

CAUTION

- Hazard or unsafe practice which, if not avoided, may result in MINOR or MODERATE

PERSONAL INJURY

and PROPERTY DAMAGE.

GENERAL WARNINGS

WARNING

1. READ THIS MANUAL COMPLETELY BEFORE USING AND THOROUGHLY UNDERSTAND AND FOLLOW

ALL SAFETY INSTRUCTIONS.

2. The EZ Loader is designed for use with stable, uniformly distributed loads on a solid level ﬂ oor. DO NOT

concentrate the load at one point on the pallet or platform. ALWAYS uniformly distribute each layer of load over

the supporting surface. DO NOT use the EZ Loader for any purpose other than its intended use.

3. SHEARING HAZARD. ALWAYS keep hands and feet clear of the scissor mechanism and all moving

components. DO NOT put hands under the platform when in use. SEVERE PERSONAL INJURY could result.

4. CRUSHING HAZARD. ALWAYS keep hands and feet clear of all moving components. DO NOT put feet on the

base frame when in use. SEVERE PERSONAL INJURY could result.

5. PINCH POINT HAZARD. ALWAYS keep hands and ﬁ ngers clear of the underside of the rotator ring. SEVERE

PERSONAL INJURY could result.

6. NEVER sit, stand or ride on the platform or rotating surface. Moving components could cause loss of balance.

SEVERE PERSONAL INJURY could result.

7. NEVER go under the platform until the load is removed and the scissor mechanism is blocked. SEVERE

PERSONAL INJURY could result.

8. NEVER place any load on the EZ Loader with the scissor mechanism blocked. SEVERE PERSONAL INJURY

and PROPERTY DAMAGE could result.

9. DO NOT overpressurize or overload the EZ Loader. ALWAYS stay within the designated pressure and capacity

ratings. SEVERE PERSONAL INJURY and PROPERTY DAMAGE could result.