User Manual

13
WARNING
NEVER go under the platform until the load is removed and the scissor
mechanism is blocked. SEVERE PERSONAL INJURY could result.
WARNING
Before servicing any component in the EZ Loader’s pneumatic system,
ALWAYS open the purge valve and discharge all air pressure. SEVERE
PERSONAL INJURY could result.
Monthly inspection should consist of the following:
1. Inspect the snap rings at all rollers and linkage assemblies. If not in place and/or secure, replace or repair at
once.
2. Inspect all rollers for signs of wear. Replace as necessary. Rollers and axles have lifetime lubricated bearings;
therefore, they do not need to be greased or lubricated.
3. Inspect the air spring retaining screws for tightness. Tighten if necessary.
4. Inspect the rotator ring bearings for ease of operation. Replace if necessary.
5. Should removal of the air lines be required,
mark the initial position before removing the
fi tting nut. When reinstalling, fi rst tighten the
nut by hand, then using a wrench rotate the
nut to the original position. Tighten the nut an
additional 1/8 turn. Do not over tighten as air
leakage may occur.
6. Inspect the EZ Adjust knob and valve body for
proper operation. If disassembly of the valve
is required, always engage the maintenance
bars and open the purge valve to completely
discharge all air pressure before disassembling
the valve.
Figure 11 Fitting Disassembly