Instruction manual

Paseo /
Rapid 2
Bischoff & Bischoff GmbH • 04.05.2011 17
English
4.2 Entering and leaving
Make sure that the scooter is switched off before sitting on it.
• Set the steering column to the upright position, as described
above, and swing the arm rest backwards to the side on
which you wish get onto the scooter.
• It is easier to sit on the scooter by turning the seat 90° to
the side on which you wish get onto the scooter (see the sec-
tion on basic adjustments).
• Now sit down on the seat.
• Rotate the seat to the direction of travel or swing the arm
rest forward.
Caution! Make sure that the seat is locked
again.
• Adjust the steering column so you can easily reach all controls.
• To get off the scooter proceed in reverse order. First remove
the key from the ignition and make sure that the scooter will
not move away.
Operate the scooter for the first time in a spacious area.
• Make sure that you are correctly seated on your scooter.
Keep the speed as low as possible. When you feel more se-
cure with the scooter you can increase the speed.
• Please make sure that your thumbs are not on the forward
/reverse lever when you switch on the scooter. This will
cause your scooter to display an error message. Switch it off
and on again to correct this error.
Fig. 12