Technical data

• Care is required when moving backwards. Ensure that your speed

is low before moving backwards. Please keep in mind that when

moving backwards you need to steer in the opposite direction.

Practice is necessary. Practice in an open, level space.

• If you are driving in a sharp bend, turn the handlebar before ac-

celerating. Always drive in a large arc around corners and obsta-

cles and drive slowly and carefully.

• With the drive engaged, braking occurs automatically when the

control lever is released. Do not push or move the scooter then, as

the motors brake automatically.

4.4 Pushing mode

If you would like to push the scooter in certain situations, you must

unlock the brakes. In freewheel mode, the scooter is easy to push.

• Pull the release lever in upward direction.

• A slight jerk tells you that the drive mechanisms are now un-

locked.

• To engage simply pull the button upwards, it will click into place

automatically.

4.4.1 Braking when being pushed

There is a manual locking brake on your scooter (as described in

Section 2.3). This can be used to aid braking with the drive en-

gaged, but serves as a locking brake with the drive disengaged.

To activate the locking brake, pull the brake lever towards you until

the brake locks on. To unlock the brake, operate the lever again.

4.5 Overload switch

If the motor is overloaded, e.g. due to driving uphill for a long time,

this automatically switches the motor off.

In this way, the motor and electrical components are conserved.

After switching off the motor in this way, please wait a few minutes

before pressing the overload switch. (See Fig. 24)

The overload switch is on the seat bracket directly under the hous-

ing cover. (See Fig. 25)

The scooter should now work properly again. If it does not, contact

your specialist retailer or the Bischoff & Bischoff customer service.

2120

Caution! Danger of life! The drive mechanisms may

only be disconnected on an even surface.

Caution! As a result, the electromechanical brake is

put out of operation.

For safety reasons, the motor drive is blocked in the

pushing mode.

Please note that, for safety reasons, the speed when

moving backwards is only half of the forward speed.

Ethon