Technical data

• Turn the sharpener dial to position 2 and run for 15 seconds to take the burr off

the front edge of the blade.

• Stop the machine using the STOP/OFF button.

• Remove the sharpener from the slicer.

• Reset the thickness knob to the 0

or closed position.

• Clean the blade.

MAINTENANCE

GENERAL

WARNING: SHARP BLADE AND MOVING PARTS!

To Avoid Serious Personal Injury:

• ALWAYS place the slicer in the STOP/OFF position and remove the plug from

the outlet/power source (before performing any maintenance on the slicer).

• ALWAYS place slicer thickness dial in 0

or closed position (before performing

any maintenance on the slicer).

• ALWAYS wear protective gloves when maintaining the slicer.

• NEVER perform any unauthorized maintenance on the slicer.