Technical data

11
INSTALLATION
STALLING THE SLICER
the operator and free of any
bstacles that might interfere with the use of the slicer.
LECTRICAL CONNECTION
with
e slicer into an approved socket that meets local building and electrical codes.
. NEVER use a
all mounted or other switch to turn the slicer on or off.
er (supply line,
utlet, distribution panel, circuit breaker or fuse box, grounding, etc.).
10 volt 60 Hz power source at 15 amps
with the slicer.
TEST THE CONTROLS
START AND STOP BUTTONS
chine works properly.
• to stop the blade (2).
WARNING LABELS
ls supplied with the slicer are in place and properly
affixed to the machine.
12
IN
Position the slicer on a well-leveled, smooth dry area that is able to hold the weight
of the slicer. Make sure the installation area is open to
o
E
Check to ensure the Start/Stop Button is in the Stop (Off) position and the slice
adjustment knob is set to “0” mm or closed. Insert the three-prong plug supplied
th
ALWAYS use the Start/Stop Button to operate the slicer
w
The user is responsible for the proper electrical connection to the slic
o
Only use 1
• Press the green button (1) to start running the blade.
• The power light turns on to indicate the ma
Press the red button
• Check to ensure all labe