Specifications

INSTALLATION

TO AVOID SERIOUS PERSONAL INJURY

PROPERLY INSTALL EQUIPMENT IN ADEQUATE WORK AREA

ALWAYS Use Qualified Technician and Electrician for Installation.

ALWAYS Connect to Proper Voltage & Phase.

ALWAYS Install Equipment in Work Area with Adequate Light and Space Away From Children

and Visitors.

ONLY Operate on a Solid, Level, Non-Skid Surface.

NEVER Bypass, Alter, or Modify This Equipment in Any Way From Its Original Condition.

NEVER Operate With Tray And/Or Tray Guard Removed, or Magnetic Safety Switch By-Passed.

NEVER Operate Without all Warning Labels Attached and Owner/Operator Manual Available to

the Operator.

UNCRATING AND SET UP

1. Read this Manual thoroughly before installation and operation. Do not proceed with installation and operation if

you have any questions or do not understand anything in this Manual. Contact your local Distributor, or BIRO

first.

2. Install machine on a level, solid, non-skid surface in a well-lighted work area away from children and visitors.

3. After installing machine in operational area, it is imperative that the four adjusting legs be adjusted to level the

machine and also eliminate rocking.

4. This machine is complete except for a knife and plate. There is a bowl shipping plug (stamped steel) placed in

the output end of the grinding bowl to retain the grinding worm during shipment. REMOVE THE BOWL

SHIPPING PLUG AND THE GRINDING WORM.

5. After checking and making sure the power supply is correct, plug in your machine. NEVER OPERATE

MACHINE WITHOUT TRAY AND GUARD INSTALLED (Machine will not run with tray removed).

6. Machine must be properly grounded. Use qualified electrician to install according to building codes.

MOTOR WIRING AND ELECTRICAL REQUIREMENTS

(A) Interchange of current is made in motor outlet box. Leads are properly marked. Changing instructions are

on the motor plate or motor outlet box.

(B) All grinders are wired 220 volts unless otherwise specified. Be sure motor specifications (voltage, cycle,

phase) match power supply line. Be sure line voltage is up to specification.

ALWAYS LEVEL MACHINE BEFORE USING