Specifications

MAINTENANCE
ROTATING GRINDING WORM
TO AVOID SERIOUS PERSONAL INJURY
ALWAYS Turn Off, Unplug From Power Source and Perform Lockout/Tagout Procedure to This
Machine BEFORE Servicing.
NEVER Touch This Machine Without Training and Authorization By Your Supervisor.
NEVER Place Hands Into Machine Input or Output Openings.
NEVER Bypass, Alter, or Modify This Equipment in Any Way From Its Original Condition.
PROMPTLY REPLACE Any Worn or Illegible Labels.
USE ONLY GENUINE BIRO Parts and accessories Properly Installed.
A. GRINDING BOWL INSTALLATION
1. Mount the grinding bowl on the two threaded studs on the front of the machine. Tighten in position with
provided nuts.
2. Place the grinding worm in the grinding bowl and fully seat rear drive tang into worm drive shaft.
3. Install knife, breaker plate and end retaining ring.
ONLY HAND TIGHTEN RETAINING RING
4. When the bowl assembly is mounted and tight, there should be approximately
1
8
" gap between the back
inside wall of the bowl and the back of the worm (SEE FIGURE 1). The bowl ring wrench which is provided
with each grinder is used only for REMOVAL of the end retaining ring for cleaning purposes or for changing
knife and breaker plate.
5. To check wear: With bowl assembly removed, place a straight edge across outside flange of aluminum
bearing housing. The end of the worm drive shaft should just contact the straight edge, i.e. flange face and
worm drive shaft end should be in the same plane (SEE FIGURE 2).
8