User Guide

Static IP address
To enable a static IP address, change configuration
method to static and fill in the details required in
Address, Mask and Gateway. Particular attention
should be paid to the Address and Mask fields as
incorrect information entered will result in P100 not
being visible on the network and a factory reset will
be required in order to recover the unit.
IP address recovery
In the event that the P100 is not visible on the
network, the network has changed, or the static IP
address details have been lost, reset the BirdDog
back to its default settings by following the factory
reset procedure.
BirdDog name
You can name each P100 with a friendly name that
makes sense for each production (Camera 1,
Camera 2, etc). This name will appear on any NDI
receiver when it looks for video coming from P100
over the network. The name must not include any
special characters and can be any combination of
‘a-z, 1-0, and –‘.
Note: no uppercase characters are valid.
On NDI receiving devices, P100 will present as a
source as follows:
birddog-name [CAM]
when the unit is set to automatic input.
10