How to Guide

300 N. Oakley Blvd.
Chicago, IL 60612
Tel: [phone]
Fax: [phone]
EPA Est. No. 075130-OR-001
Web Page:
www.bird-x.com
E-Mail:
[e-mail]
ULTRASON X INSTRUCTIONS
PRIOR TO INSTALLATION
Your complete Ultrason X kit includes a control unit, power adapter, mounting hardware and four speakers. Open the
control unit by lifting the two latches on the side of the enclosure. Route the speakers and power cables from their
respective jacks on the control panel down through the cable strain relief in the lower part of the enclosure.
INSTALLATION
Important safety related information:
1. Do not install the device during rain or snow conditions.
2. Installation shall be made in such a way that a power supply and the internal part of the control unit never be
subjected to water or snow.
3. Note that a power supply powered from 230 VAC (Model LB120050) is intended for indoor use only.
1) Use the mounting hardware to mount the control unit box to a wall, post or other vertical surface.
2) Plug the AC power adapter into a standard household 110V outlet or an outdoor rated outlet protected from moisture.
An optional 220V adapter is available for use with 220-volt source power. The other end of the cable should already be
plugged into the power jack located below POWER JACK on the front panel of the control unit box. The adapter shall
remain readily operable.
3) Speaker positioning: In general, place speakers at the level of the birds, and as close as possible to the infested
area. Position them either in a central area facing out, or in four outer areas facing further out. Birds should be
constantly exposed to the greatest sound diversity without too much physical obstruction of the sound waves. If you’re
not sure exactly where you will want to place the speakers, we suggest temporary installations with wire ties until you
determine where you want them permanently. The four individual speakers feature 100 feet of speaker cable that
enable them to be positioned in a wide array of areas for optimal coverage.
4) Set the frequency, as desired. (See “PROGRAMMING YOUR ULTRASON X” for complete details).
5) Slide the power switch to the ON position. The unit may take a few seconds before starting. The red light will be lit
continuously whenever the unit is operating.
6) Close the cover and latch shut. Ensure that the cover is properly latched closed and do not open the cover during
rain or other conditions that would expose the inside of the control unit to water.
PROGRAMMING YOUR ULTRASON X:
FREQUENCY SWITCH
HIGH, MED and LOW refer to the frequency of the ultrasound waves (not volume). We recommend you begin on LOW,
and then vary between the three every so often (for example, during routine maintenance operations in the area).
POWER SWITCH
The power switch enables the unit to operate. Slide the switch to the ON positio
n to start the unit. If you turn the unit
OFF, be sure to leave it off for about 30 seconds before turning it back on to allow the electronics to properly reset.
HOW THE SOUNDS MOVE FROM SPEAKER TO SPEAKER
Each speaker broadcasts sounds for two seconds then switches to the next speaker in sequence.
(Note: Occasionally, any given speaker may emit a high-frequency squeak in addition to its regular ultrasonic
sound wave. This is completely normal, and is caused by this type of speaker working with this type of sound.)
PREVENTATIVE MAINTENANCE
Since 1964, our products have provided years of trouble-free service with only a minimum of routine maintenance. This
unit is specifically designed for extensive outdoor use and temperature extremes. The electronic circuits inside the unit
are coated for oxidation and moisture protection and need no maintenance. For the longest life of external components,
clean off any excess dirt or corrosion. Twice a year, lubricate the switch sockets and the connections with silicone spray.