SDS

JIANGSU CEL BATTERY CO.,LTD.
No.199,Jinhe Road,Jinhu County,Huaian City,Jiangsu Province, 211600 P.R.China
Tel: [phone] Fax: [phone] MSDS NO:20110530
The information and recommendations set forth are made in good faith and believed to be accurate as of the date of preparation.
Cel Battery Co., Ltd. makes no warranty, expressed or implied, with respect to this information and disclaims all liabilities from
reliance on it.
3
7.Precautions for Safe Handling and Use
Storage: Store in a cool place, but prevent condensation on cell or battery terminals. Elevated
temperatures may result in reduced battery life. Optimum storage temperatures are between -31°F and
95°F.
Mechanical Containment: If there are special encapsulation or sealing requirements, consult your Cel
Battery Co., Ltd. representative about possible cell hazard precautions or limitations.
Handling: Accidental short circuit will bring high temperature elevation to the battery as well as
shorten the battery life. Be sure to avoid prolonged short circuit since the heat can burn attendant skin
and even rupture of the battery cell case. Batteries packaged in bulk containers should not be shaken.
Metal covered tables or belts used for assembly of batteries into devices can be the source of short
circuits; apply insulating material to assembly work surface. If soldering or welding to the case of the
battery is required, consult your Jiangsu CEL Battery Co., Ltd. representative for proper precautions
to prevent seal damage or external short circuit.
Charging: This battery is designed for recharging. A loss of voltage and capacity of batteries due to
self-discharge during prolonged storage is unavoidable. Charge battery before use. Observe the
specified charge rate since higher rates can cause a rise in internal gas pressure that may result in
damaging heat generation or cell rupture and/or venting.
Labeling: If normal label warnings are not visible, it is important to provide a device label stating:
CAUTION: Do not dispose in fire, mix with other battery types, charge above specified rate, connect
improperly, or short circuit, which may result in overheating, explosion or leakage of cell contents.
8.Safe Handling and Use (Personal Protective Equipment)
Ventilation Requirements: Not required under normal use.
Respiratory Protection: Not required under normal use.
Eye Protection: Not required under normal use.
Gloves: Not required under normal use.
9.Physical Data for Battery
Melting point (°F)
N
A
Boiling point (°F)
N
A
% Volatile by Volume
N
A
Vapor Pressure (mm Hg)
N
A
Evaporation Rate Vapor Density (Air = 1)
N
A
Specific Gravity (H2O) Solubility in Water Appearance and Odor