User guide

Bird Technologies
30
Figure 10 Setting a Limit Line
Step Action
1 While in the Measure Match mode or the
Fault Location mode, press the Limit Test
key:
First press - Test ON Aud (line and sound)
Second press - Test ON (line only)
Third press - Test OFF
2 Press the Config key
3 Press the Limit Line softkey
4 Use the keyboard to enter a limit value of
your choice or use the suggested limits
listed below (use the +/- key to enter a nega-
tive value) then press the Enter key.
Antenna at resonance -14 dB
Connectors -25 dB
Jumpers -35 dB
Lightning protector -25 dB
Transmission lines -30 dB
5 Press the Esc key to exit the configure
screen