User guide

Measure Match Mode
19
 Note: If you enter a frequency that is outside of the range
of the Site Analyzer, the Site Analyzer will override your entry
and set the minimum or maximum frequency of the model.
1. Make sure that the unit is turned on and in the Measure Match
mode (refer to
Select the Measure Match Mode, page 18).
2. Follow the numbered steps in Figure 4 on page 19 to set a custom
frequency or follow the steps in Figure 5 on page 20 to select from
a preset band list.
Figure 4 Setting a Custom Sweep Frequency
Step Action
1Press the Config key
2Press the Freq softkey
3 Use the left or right scroll keys to select
Start, Stop, Center, or Span
4 Use the keypad keys to enter a value
and press Enter when finished.
5Press the Esc key to exit the configura-
tion screen