User guide

Bird Technologies

Select the Measure Match Mode

Follow the numbered steps in Figure 3 to turn ON the Site Analyzer

and select the Measure Match mode.

Figure 3 Selecting the Measure Match Mode

Setting the Measurement Frequency

You must be in the Measure Match mode to set a frequency.

Frequencies can be set manually or chosen from a list of presets (band

list). If the start, stop, center, or span frequency is manually set, the

band list will indicate “Custom”. Be sure to set the frequency to a

value that is well beyond the normal range of the antenna. For exam

ple, for a 450 MHz antenna, set the start frequency at 400 and the

stop frequency at 500 MHz, for an 800 MHz antenna, set the start fre

quency at 700 and the stop frequency at 1,100 MHz.

 Note: Changing the frequency settings will automatically

turn calibration off. Always set the frequency before calibrating

the unit.

Step Action

1 Turn On the Site Analyzer. Press ON/

OFF key for ½ second.

2 Press the MODE key

3 Press the Measure Match key