User guide

58
Assembly Object – Class Code: 4 (04
HEX
)
Table 5-17 Assembly Class Attributes (Instance 0)
Attrib Rule NV Name
Data
Type
Description Value
1 Get NV Revision UINT Revision level of this
object.
2
2 Get NV Max Instance UINT Maximum instance
number.
101
100 Set/
Set
V Input Assembly
Instance ID
USINT Selected input
assembly instance
ID. Changing the
value of this attribute
will also change the
value of the “Input
Assembly Size”
attribute.
One of the
following:
100 (64
HEX
)
101 (65
HEX
)
Default: 101
101 Get V Input Assembly
Size
UINT Selected input
assembly size in
bytes – the number of
bytes produced by
the BDS for the
selected assembly.
Setting the “Input
Assembly Instance
ID” attribute will
change this value.
Setting the “Num
Fundamentals” or
“Fundamental
Selection” attributes
from the “Standard
Mode” class will also
change this value.
Based on the
Input
Assembly
Instance ID
attribute and
the Standard
Mode object
configuration.
Inst 100: 10-
2760
Inst 101: 96
Default: 96
bytes
102 Get V Num
Measurements
USINT The total number of V
& I measurements
contained in the
selected input
assembly instance.
This value is based
on the “Standard
Mode” configuration.
Based on
Standard
Mode object
configuration.
Min: 0
Max: 110
Default: 0
103 Get V System Status DWOR
D
BDS system status
bitfield.
Note: Changing any
attributes in the
“Standard Mode” or
“Application” classes
will reset the status
(to a value of 0).
See “BDS
System Status
Bitfield” in the
Appendix for
status bit
descriptions.
A value of 0
means nothing
to report.
104 Get V Timestamp DATE_
AND_
TIME
Data acquisition
timestamp.