Manual

Component Description

Figure 1 BPM-E Components

Item

(Fig. 1)

Function Description

1 RF Input Input to BPM-E from transmitter

2 Power/Alarm

Parallel Port

Connects to the 3129 digital display using a

15 pin cable.

Note: Also used for remote

operation.

3 RS-232 Serial

Port

Connects to a 3129 digital display, a PC, or

other display panel using a 9 pin RS-232

cable

4 Alarm LED Red LED, lights when an alarm is triggered

5 Monitor On

LED

Green LED, lights when the unit is powered

6 Reset Switch Press to reset the alarm. If an alarm trigger

is still present, the alarm will reactivate

7 Ethernet Port Connects to a network or PC ethernet card

8 RF Output Output from BPM-E to antenna or load

9 RF Test Port Insert a sampling element with an

appropriate connector to connect to a

monitor device (e.g. spectrum analyzer,

modulation monitor, oscilloscope)