Operation Manual

Fiber Distributed Antenna System (Fiber DAS)
85
FOI Reset to Factory Default
To reset the FOI to factory default, carefully press the “Reset” button (see Figure 91 ) for 10 seconds. This is helpful
when a card fails to appear in the Configuration menu.
Figure 91 FOI Reset Button
Reset
FOR
The initial screen for the FOR provides basic information such as name, serial number, part number and active
alarms. The Locate me! button causes an LED to flash on the chassis so that the unit can be identified in the field.
Note: If the fiber is just now connected to the FOI card, it could take up to 30 minutes for the FOI to
assign an IP address to the FOR. See section for "Moving Remotes to Different FOI Port" on page 96 for
details on how to quicken the IP assignment.
Figure 92 FOR Welcome Screen