Operation Manual
Table Of Contents
- Safety Precautions
- About This Manual
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 System Description
- Chapter 3 Installation guidelines
- Chapter 4 DAS Software Configuration
- Chapter 5 Commissioning
- Chapter 6 RF Commissioning
- Chapter 7 Troubleshooting
- Alarms
- Base Station Gateway (BGW) Alarms
- Fiber Optic Remote (FOR) Alarms
- Remote Unit (RU) Alarms
- Fiber optic Interface (FOI) Alarms
- Base Station Interface (BIU) Alarms
- Medium Power Amplifier (PA) Alarms
- Variable Gain Amplifier (VGA) Alarms
- Analog Pre-distortion (APD) Amplifier Alarms
- Multi-carrier Power Amplifier Interface (MPI) alarms
- Alarms
- Chapter 8 Model Identification
Safety Precautions
iv
Caution Statements
The following equipment cautions appear in the text and are repeated here for emphasis.
CAUTION
Turn Off Test Tone
Do not forget to turn off the test tone when you are done with your
uplink. Better check one extra time. They will
otherwise interfere with the normal operation of the system by causing noise to the base station.
See
page 118
CAUTION
Unauthorized antennas, cables, and/or coupling devices may cause non-conformity with national or international
regulations, could cause damage, or non-conforming ERP/EIRP.
See
page 44
.
CAUTION
When mating RF connectors, ensure that they are properly aligned and not cross threaded.
Tighten SMA connectors to 8 in.-lbs.
Do over torque RF connectors, this could result in damage to the Unit.
Do not under torque RF connectors, this could result in poor signal transmission.
See
page 50