Operation Manual
Table Of Contents
- Safety Precautions
- About This Manual
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 System Description
- Chapter 3 Installation guidelines
- Chapter 4 DAS Software Configuration
- Chapter 5 Commissioning
- Chapter 6 RF Commissioning
- Chapter 7 Troubleshooting
- Alarms
- Base Station Gateway (BGW) Alarms
- Fiber Optic Remote (FOR) Alarms
- Remote Unit (RU) Alarms
- Fiber optic Interface (FOI) Alarms
- Base Station Interface (BIU) Alarms
- Medium Power Amplifier (PA) Alarms
- Variable Gain Amplifier (VGA) Alarms
- Analog Pre-distortion (APD) Amplifier Alarms
- Multi-carrier Power Amplifier Interface (MPI) alarms
- Alarms
- Chapter 8 Model Identification
Fiber Distributed Antenna System (Fiber DAS)
109
Figure 129
1516
BGW Configuration - Ethernet Status
Rolling Back Modem Configuration
If the external modem is no longer required the configuration can quickly be rolled back.
1. Click on Configuration. See
Figure 130
.
2. Click on External Comm.
3. Select the Ext Ethernet tab.
4. Enter original IP addresses that used prior to installing the modem.
Figure 130 Rollback Modem IP Addresses
4
12
3
5. Select the DNS Forwarders tab. See
Figure 131 on page 109
.
6. Select the "No" radio button.
Figure 131 Stop DNS Forwarding
5
6