Operation Manual
Table Of Contents
- Safety Precautions
- About This Manual
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 System Description
- Chapter 3 Installation guidelines
- Chapter 4 DAS Software Configuration
- Chapter 5 Commissioning
- Chapter 6 RF Commissioning
- Chapter 7 Troubleshooting
- Alarms
- Base Station Gateway (BGW) Alarms
- Fiber Optic Remote (FOR) Alarms
- Remote Unit (RU) Alarms
- Fiber optic Interface (FOI) Alarms
- Base Station Interface (BIU) Alarms
- Medium Power Amplifier (PA) Alarms
- Variable Gain Amplifier (VGA) Alarms
- Analog Pre-distortion (APD) Amplifier Alarms
- Multi-carrier Power Amplifier Interface (MPI) alarms
- Alarms
- Chapter 8 Model Identification
Fiber Distributed Antenna System (Fiber DAS)
93
FOR Application Handling
The application handling page allows for software reset and rebooting functions.
Note: Only the Reboot command should be used by the technician. All other functions should only be
used under supervision of Bird engineering as they may cause data corruption if not initiated properly.
Figure 103 FOR Application Handling
Slave FOR
A Slave FOR is when a remote has a second FOR installed. The Slave FOR is most likely to be used when the remote
is configured for MIMO or has multiple amplifiers in the same band or has redundant fiber.
Settings for the Slave FOR is the same as the main FOR except, “Calc ip for ETH0 is set to “No”.
Figure 104 Slave FOR Network Settings