User's Manual

TX RX Systems Inc. Manual 7-9469-1.7 02/08/10 Page 10
Message Context
Ready to connect
The Applet has finished loading and has not attempted to connect to the
control board.
Network connection established Upon successful connection to the control board.
Not connected
The Applet either is not connected or has failed to connect to the control
board.
No network connection Unable to reconnect to the control board.
Table 3: Connection status messages.
Message Context
Obtained startup data successfully
Connection to control board has been established and data and settings for
the active module uplink/downlink have been successfully obtained.
Failed to connect to booster Initial attempt to connect to the control board failed.
Network client restarting Reconnecting to the control board.
Network connection restarted Reconnected to the control board successfully.
The page was reloaded Successful reload of settings or data for a page (Admin, System, CPS)
Submitting network settings
User clicked the “Submit” button to send the network settings to the control
board.
Failed to submit network settings An error occurred while sending network settings to the control board.
Network settings updated successfully The network settings have been sent and applied successfully.
Password settings updated successfully The password settings have been sent and applied successfully.
Failed to update password settings An error occurred while sending password settings to the control board.
Requesting device readings
Requesting data from the control board for the active module (temperature,
current measurements, etc...)
Obtained device readings Obtained data successfully
Submitting system settings
User clicked the “Submit” button to send the system settings to the control
board.
System settings submitted The system settings have been sent and applied successfully.
Failed to submit system settings An error occurred while sending system settings to the control board.
Data Sequencer : Error submitting query General communication message error.
Sending the factory reset command User clicked the “Factory Reset” button.
The factory reset command was sent The control board has restored factory default settings.
Sending the device ID command User clicked the “Send ID” button.
The device ID command was sent The control board has executed the “Send ID” command.
Sending the device clear errors command User clicked the “Clear Errors” button.
Table 4 (part 1): System status messages.