User's Manual
Adjust the saddle5
AFRAME
Remove the cap that’s covering the seat clamp screw, which is located just
below the seat.
Insert the seat post into the seat tube. To adjust the height, move it to where
it feels comfortable, then tighten the seat clamp screw with the 5mm end
of the Y-wrench. Be sure to replace the cap once the seat post is set and
tightened.
Warning: do not extend the seat post
farther than the minimum insertion line
that is indicated on the seat post.
wh
ic
h
is
l
ocate
d
j
ust
gh
t, move it to w
h
ere
w
it
h
t
h
e 5mm en
d
a
t post is set an
d
Y-wrench
Attach the pedals6
10
L R
Install the left and right pedals by screwing them into the crank.
Pay attention to which pedal is being installed on the left and
the right as the left pedal is reverse threaded so it is tightened
counter-clockwise. You can tell the two pedals apart by looking
for the “R” on the right pedal and “L” on the left.
After the pedals are screwed on by hand, use the 15mm end of
the wrench to give the pedals a final tightening.
PedalsWrench