User's Manual

Y-wrench
3
AFRAME
Attach the front fender
Attach the front fender to the fork by using the screws that are already in the fork legs.
Use the 4mm end of the Y-wrench to remove the two screws from the fork legs and then
tighten the screws through the holes at the end of the fender mounts.
Using the 4mm end of the Y-wrench remove the screw that’s on the top of the backside
of the fork and tighten the screw through the fender mount bracket on top of the fender
so that it’s secured tightly to the back of the fork.
ac
k
o
f
t
h
e
f
or
k
.
When tightening the fender, avoid
rubbing the Y-wrench on the
frame so the paint doesn’t get
scratched. Also, don’t over
tighten the screws to avoid
stripping the holes.
WrenchCap Nut and
Washer
Install the front wheel4
Be sure to remove the plastic front rotor protector from the front wheel axle
before starting this step.
Align the front wheel axle so that it’s inside of the fork slots on both sides. The side
with the brake rotor should be aligned so that it fits inside the front disc brake.
Once the fork slots are sitting on both sides of the axle, install washers at both
ends and tighten up the cap nuts on the outside using the 15mm end of the
wrench.
ector
f
rom t
h
e
f
ront w
h
ee
l
ax
l
e
f
t
h
e
f
or
k
s
l
ots on
b
ot
h
si
d
es. T
h
e si
d
e
t it
f
its insi
d
e t
h
e
f
ront
d
isc
b
ra
k
e.
of
t
h
e ax
l
e, insta
ll
was
h
ers at
b
ot
h
s
i
d
e using t
h
e 15mm en
d
o
f
t
h
e
8
After installing the front wheel, extend the kickstand for
better stability and easier assembly during the next steps.