User's Manual

AFRAME

Install the handlebar2

Remove Display from the Handlebar

Use the 2.5mm Allen Key to remove the screw that’s behind

the display on the handlebar. If the display isn’t easily removed

from the handlebar, use the hex key to gently push it from the

back of the handlebar through the hole from where the screw

was removed.

2.5 mm Allen key

VFRAME

Y-wrench

Install the Handlebar

Use the 5mm end of the Y-wrench to remove

the hex bolt from inside the steerer tube and

insert the handlebar over the steerer tube.

After the handlebar is installed and lined up

properly with the tire and frame, insert the

hex bolt through the handlebar and into the

steerer tube.

Use the 5mm end of the Y-wrench to gently

tighten the hex bolt into the handlebar so that

there’s no play between the fork and frame.

Finally, make sure the handlebar, frame, and

front wheel are still aligned and tighten the

two steering stem screws with the 5mm end

of the Y-wrench so the handlebar stays

in place.