User's Manual

When P3 is displayed in the speed position
while in Settings Mode, the wheel diameter
setting will be shown in inches and can be
adjusted with the +/- buttons. Be
sure to know the proper sizes as selecting
the wrong size can result in unexpected
speeds. After selecting, press the
power button so save.
DISPLAY BRIGHTNESS P4
When P4 is displayed in the speed position
while in Settings Mode, the display
brightness settings from 1 to 5 are displayed
according to the current setting. 1 is the
lowest brightness setting, and 5 is the
highest (default setting is 5).
After the setting is completed, short press
the power button to save.
DARK BRIGHT
12345
WHEEL DIAMETER P3
2626
When P5 is displayed at the speed position
while in Settings Mode, choose 0-9 by
using the +/- buttons, which
represents the automatic shutdown time in
minutes. The default setting to power off
automatically after 5 minutes and setting
the timer to 0 means that auto power off
will be disabled. After selecting, short press
the power button to save.
AUTOMATIC POWER OFF TIMER P5
SERVICE REMINDER:
After the BirdBike has been ridden 300 miles
(500km), there will be a service
inspection reminder shown on the display the
next time it’s turned on. If the reminder isn’t
marked as complete, then it will be displayed
every time the vehicle is turned on. The reminder
can be cleared by a short press of the power
button.
To remove the service reminder completely until the
next 300 miles (500km), the rider must connect to
the BirdBike through the Bird App and mark the
service inspection as complete. Once marked
complete in the Bird App, the service reminder will
then no longer be displayed by default each time the
BirdBike is powered on.
When P6 is displayed at the speed position
while in Settings Mode, press the +/-
buttons to select either Y or N. After
selecting Y, short press the power
button to reset the trip meter to 0. After
resetting the trip meter, short press the
power button to save the parameters.
RESET TRIP METER P6