User's Manual

Attach the pedals5
L
R
PedalsWrench
Install the left and right pedals by screwing them into the crank.
Pay attention to which pedal is being installed on the left and
the right as the left pedal is reverse threaded so it is tightened
counter-clockwise. You can tell the two pedals apart by looking
for the “R” on the right pedal and “L” on the left.
After the pedals are screwed on by hand, use the 15mm end of
the wrench to give the pedals a final tightening.
Install the display6
2.5 mm Allen key
20
For the final step before powering on your BirdBike, reinstall the display back into
the handlebar so that the Bird logo is at the bottom. Be sure to not pinch the cable
inside of the handlebar while reinstalling. Once reinstalled, use the 2.5mm Allen key
to replace and tighten the screw under the display so that it’s tightened into place
inside of the handlebar.
Connect the one end of the power cable coming from the bottom of the display
to the other end of the power cable that is coming out of the bottom of the frame.
At this point you can power on your BirdBike, but be sure to read through the rest
of this manual before riding.