US E R MAN UAL
AFRAME A-Frame & V-Frame User Manual Please read this manual very carefully before using the product. The manual contains important instructions for the safe use and longevity of your bike. If you need any type of support or warranty information for your BirdBike, please contact us before returning it back to wherever you purchased it. The BirdBike Support Team is ready to help you via phone or email and you can also visit support.bird.co for more info.
1 Assembly Prep Frame Handlebar Saddle To prepare for the assembly of your BirdBike, first take out all pieces of the BirdBike from the box and remove all packaging. Also, open the accessory box and remove all tools, parts and everything else that’s inside of it. Tail light Front light Front fender Rear fender Rear rim Front rim Tire 2.
2 Install the handlebar 2.5 mm Allen key Y-wrench Remove Display from the Handlebar Install the Handlebar Use the 2.5mm Allen Key to remove the screw that’s behind the display on the handlebar. If the display isn’t easily removed from the handlebar, use the hex key to gently push it from the back of the handlebar through the hole from where the screw was removed. Use the 5mm end of the Y-wrench to remove the hex bolt from inside the steerer tube and insert the handlebar over the steerer tube.
3 Attach the front fender Attach the front fender to the fork by using the screws that are already in the fork legs. Use the 4mm end of the Y-wrench to remove the two screws from the fork legs and then tighten the screws through the holes at the end of the fender mounts. Using the 4mm end of the Y-wrench remove the screw that’s on the top of the backside of the fork and tighten the screw through the fender mount bracket on top of the fender so that it’s secured tightly to the back ack of the fork.
5 Adjust the saddle Remove the cap that’s covering the seat clamp screw, which is located just below the seat. Insert the seat post into the seat tube. To adjust the height, ght, move it to where it feels comfortable, then tighten the seat clamp screw with the 5mm end of the Y-wrench. Be sure to replace the cap once the seat at post is set and tightened. Warning: do not extend the seat post farther than the minimum insertion line that is indicated on the seat post.
Install the display 2.5 mm Allen key VFRAME For the final step before powering on your BirdBike, reinstall the display back into the handlebar so that the Bird logo is at the bottom. Be sure to not pinch the cable inside of the handlebar while reinstalling. Once reinstalled, use the 2.5mm Allen key to replace and tighten the screw under the display so that it’s tightened into place inside of the handlebar.
