Manual

ManualsBrandsBird B Gone ManualsFor petsSolar Bird Repeller

web site: www.birdbgone.com

E-mail: nobirds@birdbgone.com

HOT LINE 800-392-6915

TEL 949-472-3122 • FAX 949-472-3116

BIRD•B•GONE

PRIOR TO INSTALLATION: CHARGE THE REPELLER IN FULL SUN LIGHT

FOR A MINIMUM OF 8 HOURS TO PRE-CHARGE THE BATTERIES

Bi r d re p e l l e r

Th e

Installation Instructions

1-800-392-6915

www.birdbgone.com • email: nobirds@birdbgone.com

P/N Description

RPLR-SLR1 Solar Powered Bird Repeller

Ideal for use on Billboards & Signs...

and boats!

Rooftops...

Summary of content (4 pages)

PAGE 1
B ird Repeller Installation Instructions The PRIOR TO INSTALLATION: CHARGE THE REPELLER IN FULL SUN LIGHT FOR A MINIMUM OF 8 HOURS TO PRE-CHARGE THE BATTERIES Rooftops... Ideal for use on Billboards & Signs... P/N RPLR-SLR1 and boats! Description Solar Powered Bird Repeller 1-800-392-6915 HOT LINE 800-392-6915 web site: www.birdbgone.com TEL 949-472-3122 • FAX 949-472-3116 E-mail: nobirds@birdbgone.com www.birdbgone.com • email: nobirds@birdbgone.
PAGE 2
PRIOR TO INSTALLATION: CHARGE THE REPELLER IN FULL SUN LIGHT FOR A MINIMUM OF 8 HOURS TO PRE-CHARGE THE BATTERIES STEP I: Review Contents Remove Contents from box. Contents include: 1. One Bird Repeller with Solar Panel attached. 2. Two Telescoping Wands. 3. Two Mylar Streamers for Telescoping Wands (optional - not necessary for effectiveness of operation) 1. 2. 3. STEP II: Repeller Assembly A. Remove the protective plastic from the solar panel. C.
PAGE 3
PRIOR TO INSTALLATION: CHARGE THE REPELLER IN FULL SUN LIGHT FOR A MINIMUM OF 8 HOURS TO PRE-CHARGE THE BATTERIES STEP III: Problem Analysis A. Before operation, observe the birds and inspect the affected areas. Eliminate any variables that coud be attracting birds including food, water and shelter. Eliminating these variables increases the success of your bird abatement program. B. Ensure a Clean Environment.
PAGE 4
PRIOR TO INSTALLATION: CHARGE THE REPELLER IN FULL SUN LIGHT FOR A MINIMUM OF 8 HOURS TO PRE-CHARGE THE BATTERIES C. Securing the Repeller Excess Winds can cause the Repeller to tip if not secured properly. The repeller can be mounted to most surfaces using screws. You may also use bungee cords, tie downs, etc. to secure the repeller to uneven surfaces and for easy removal. On/Off Switch Flexible Mounting Feet D. On the back of the unit is an On/Off switch.