Manual
If the Bird Spider requires gluing for the
installation, the PVC adapter must be
used.
Select the appropriate Bird Spider (4’ or
8’) depending on the surface of coverage.
Stainless Steel arms must have room to
move with the air.
Ensure mounting surface is clean of bird
feces and debris before installing any bird
deterrent, including the Bird Spider.
• It is important that the “tips” of
the arms extend several inches
over the outside surface(s).
• Use Bird-B-Gone Disinfectant or
appropriate disinfectant to
prepare the surface.
If installing more than one Bird Spider in
a row, be sure that they are installed 6-8”
from arm tip-to-arm tip (not base-to-
base).
Bird Spider Arm Tips Should be no
more than 2-3” above mounting
surface.
Any Questions Regarding
Installation:
Call
Bird•B•Gone, Inc.
Ph. 949-472-3122
FAX: 949-472-3116
Email: nobirds@birdbgone.com
www.birdbgone.com
• Attach the Bird Spider Base directly to the Boat Base
with the screws supplied.
•
• Each of the four “corners” of the Bird Spider Boat Base
has holes.
• This makes it easy to “bungee” or tie down the base to
the canopy top, cover, etc. ... and also allows for easy
removal of this ideal boat protective device!
• Use the Sandbag Base on Boats where the Bird Spider
Boat Base is not appropriate (i.e. Bimini Tops and larger
areas).
• Attach the Bird Spider Base directly to the Sandbag Base
with the screws supplied with Sandbag Base. Follow
instructions supplied with screws.
• Do not mount onto the PVC supplied
attachment first
• Although the Bird Spider Sandbag Base is weighted, it
should always be secured to the boat.
• High winds or extreme shifts in weather could remove the
Sand Bag Base and cause damage if it is not properly
secured.
•
• Use Bird-B-Gone Adhesives,
available direct from Bird-B-Gone
• Do not mount Bird Spider in an area
where the arms will be suppressed
from movement or blocked by walls.