Specification

B. Construction: Rigid one piece construction, available in 7 standard colors
including crystal clear.
C. Adaptation: “Break away” points are located between each set of screw
holes. Tin snips, hacksaw, etc. can also be used to cut the product to the
desired length.
2.4 MOUNTING SYSTEMS
A. Wood: Use #8 Wood Screws. For every 2 ft. section of Bird-B-Gone
Polycarbonate Bird Spike ten (10) #8 wood screws are required.
B. Steel, Brick, Stone or Concrete: Use an outdoor construction adhesive that
is non-silicone based. Purchase from the manufacturer or call for
recommended adhesives. If mounting surface warrants, screw or bolt
down Bird-B-Gone Polycarbonate Bird Spike in conjunction with using
the adhesive.
C. Pipes or Poles: Ty-Wraps can be used alone or in conjunction with an
outdoor construction adhesive. For U.V. protected Ty-Wraps, purchase
directly from the manufacturer or call for recommended products.
PART 3 – EXECUTION
3.1 EXAMINATION
A. Examine the installation area and note any detrimental or hazardous work
conditions. Notify contracting officer or inspector of the detrimental work
conditions.
B. Do not proceed with installation until conditions are corrected.
3.2 SURFACE PREPARATION
A. Surface should be thoroughly cleaned and free of bird droppings, nesting
materials, rust, peeling paint or other debris.
B. Remove or repair articles that may damage Bird-B-Gone Polycarbonate
Bird Spike after installation, including overhanging foliage, brush and
loose parts on the structure.
3.3 INSTALLATION
A. Install Bird-B-Gone Polycarbonate Bird Spike as recommended by the
manufacturer.
B. Bird-B-Gone Polycarbonate Bird Spike should be installed correctly,
covering the entire depth of the surface, not just the perimeter.
1. Follow the contours and angles closely: cut or break away to fit
properly.