Installation Guide

Remove protective backing from adhesive and press tape into place

Tips

• Make sure surface is clean and dry before installing

• Do not bend the LED tape

• Use painters tape to temporarily install to test

Operation

Control of the kit will be either via in-line on/oﬀ switch or included remote

Troubleshooting

LED strip will not light

• Make sure the outlet has power and that

a switched outlet switch is on

Remote unresponsive

• Move closer to the the receiver

• Check the battery and replace if needed

For support, visit birchlighting.com.

One-year limited warranty. This product is for dry

location use only. Improper installation, improper

powering, abuse, or failure to use this device for

its intended purpose will void warranty. Proof of

purchase is required for all returns.

This device complies with part 15 of the FCC

Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any

interference received, including interference that

may cause undesired operation.