Installation Guide

LED Strip Light Kits

Safety Information

• Do not stare directly at LEDs

• Do not power while LED tape is still on the reel

• Keep low-voltage wiring separate from high-voltage wiring runs

• For indoor/dry location use only

Installation

Unwind tape from reel and test prior to installation

Tape may be cut to size at the copper pads or solder joints

PAGE 1
LED Strip Light Kits Safety Information • Do not stare directly at LEDs • Do not power while LED tape is still on the reel • Keep low-voltage wiring separate from high-voltage wiring runs • For indoor/dry location use only Installation OR Unwind tape from reel and test prior to installation Tape may be cut to size at the copper pads or solder joints
PAGE 2
Remove protective backing from adhesive and press tape into place Tips • Make sure surface is clean and dry before installing • Do not bend the LED tape • Use painters tape to temporarily install to test Operation Control of the kit will be either via in-line on/off switch or included remote Troubleshooting LED strip will not light • Make sure the outlet has power and that a switched outlet switch is on Remote unresponsive • Move closer to the the receiver • Check the battery and replace if needed For s