User's Manual

28
Frequency = 24.05 ... 24.25 GHz
Max.switching voltage 48V AC/DC
Max.switching current 0.5 A AC / 1.0 A DC
Max.switching capacity 55VA / 24 W ohmic load
Connected to screw terminal
At 4.5 m (14.75 ft) mounting height and
max. field dimensions
At 24 V AC, 20° C (68° F)
At pulse width > 20 µs
Colour black
W x H x D
FCC pending
Technology
Mounting height
Outputs
Connection cable
Detection speeds
Response time
Max. Range
Operating voltage
Operating current
Current at make
Material
Dimensions
Protection class
Operating
temperature
Humidity
EMC
Weight
Approval
Doppler microwave with planar module
2.5 m to 7 m (8.2 ft to 23 ft)
2 potential-free changeover contacts
For separation of
– People/vehicles
– Direction recognition
8 x 0.14 mm
2
(AWG 26), length 8 m (26.25 ft)
Max. 25 km/h (15 mph) for vehicles
< 100 ms
25 m (82 ft)
12–28 V AC, 12–36 V DC
Max.110 mA
Max.1 A
Aluminium housing, polycarbonate cover
134 x 82 x 75 mm (5.28" x 3.23"x 2.95")
Suitable for use in acc. with IP 65
–20° to +60° C (–4°F to +140°F)
0% to 95% relative, without condensation
Directive 89/336/EEC, edition 1996
EN 61000-6-2
EN 61000-6-3
720 g (1.587 lb) incl. cable
/ FCC
Motion detector
Technical data
EC Declaration of Conformity
Bircher Reglomat AG herewith declares the product Herkules to be in conformance with the basic require-
ments and other relevant regulations as contained in the 1999/5/EG directive.
The full version of the Declaration of Conformity can be viewed on our internet homepage:
www.bircher-reglomat.com
FCC-Approval
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
• this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Warning: Changes or modifications made to this equipment not expressly approved by Bircher
Reglomat AG may void the FCC authorization to operate this equipment.