User's Manual
23
8
Programming using the push-buttons (without the remote control unit)
8.1 Setting the functions
If you make the settings with the Reglobeam remote control
unit, see chapter 7ff. For an overview of all functions with
values and factory settings see the table on page 25.
Note
– Programming must be carried out within 30 s.
After this time, programming mode must be reactivated.
Functions are set and all parameters are reset by pressing the push-buttons.
Step 1
Press both push-buttons at the same time to access the required mode
Primary mode
➔
Press both push-buttons for 2 s
➔
Green LED flashes after 2 s
Secondary mode
➔
Press both push-buttons for 4 s
➔
Green LED flashes after 2 s and after 4 s
Reset
➔
Press both push-buttons for 8 s
➔
Green LED flashes after 2 s, after 4 s and after 8 s
Push-buttons
The green LED then flashes the number of the activated
function, the red LED outputs the current level by flashing
accordingly.
Step 2
Change the function by pressing the push-button (value
is increased by one per push-button press). Once the last
function has been reached, the program jumps back to the
first function.
Change the level by pressing the push-button (value is
increased by one per push-button press).
Step 3
Exit programming mode by pressing both push-buttons
briefly at the same time.
The values that can be set in both modes are shown in the
table below.
*
Factory setting
X
1 1 8
2 2
2 1
4 1
5 1
2
2
3 1
2
2
3
4
1 1 2 3
4 5 6
7 8 9
7
Step 1 Step 2
Mode Function Both push-buttons Push-button Push-button Notes
at same time No. of function Level
(Green LED) (Red LED)
Primary Comfort level Press for 2 s … Section 7.2
Mounting height Press for 2 s …
2 = 2.50–2.90 m (8.2–9.5 ft)
3 = 3.00– 3.90 m (9.8–12.8 ft)
4 = 4.00– 4.90 m (13.1–16.1ft)*
etc.
Secondary
Field dimensions Press for 4 s , , Small
, , Medium*
, , Large
Relay hold interval Press for 4 s = 0.5 s
= 1.0 s
= 2.0 s*
= 5.0 s
Direction recognition Press for 4 s
Forwards = Towards detector*
Backwards
Active/passive Press for 4 s Aktive *
Passive
Separation between
Press for 4 s On*
people and vehicles
Off
X
Y
Push-button
Push-button
X
Y
Push-button
Red
Green
Push-button
X
Y
Y