User's Manual
20
Switching on the “access code” function
(saving the code)
6.1 6.3
6.2
6.4
Activating configuration mode
Switching off the “access code” function
(clearing the code)
Switching off the “access code” function (clea-
ring the code) without the remote control unit
Push-buttons
The Herkules can be protected against undesired manipulation by means of a four-digit access code. With this code, configuration
mode can be reactivated at any time via remote control unit (see also section 5.2) in order to adjust settings. The default setting for
the “access code” function is OFF.
6
Access code
X
Y
Push-button
Push-button
The code can only be saved if the sensor is already in
configuration mode (see section 5.2). The unit is protected as
soon as the code has been saved (configuration mode is de-
activated).
1.
Press the start key
➔
and one of the keys … light up
2.
Press and then
➔
and light up
➔
“Access code” function is switched off
(no code is saved)
3.
Enter four-digit code
(any number from 1111 to 9998 can be chosen)
4.
Press
➔
and light up
➔
“Access code” function is switched on
(code is saved)
➔
Configuration mode is deactivated
(unit is protected)
G
G 1 4
C
C
9
C
C
2
1
Configuration mode can only be activated by remote control
unit if a code has been saved previously (see section 6.1).
1.
Press the start key
➔
and one of the keys … light up
2.
Press and then
➔
and light up
➔
“Access code” function is switched on
3.
Enter your four-digit code
4.
Press
➔
and light up
➔
Configuration mode is activated
➔
Sensor is ready to be programmed
➔
If and light up, then the code entered
is wrong
➔
Start again at step 1.
G
1 4
C
C
9
C
G
C
1
1
C 2
The code may only be cleared when the sensor is in
configuration mode (see section 5.2).
1.
Press the start key
➔
and one the keys … light up
2.
Press and then
➔
and light up
➔
“Access code” function is switched on
3.
Press our times and then press
➔
and light up
➔
“Access code” function is switched off
(code is cleared)
G
C 1
C 9
C 2
9 C
G
1 4
Important: all unit parameters are set to
factory default.
Press the push-buttons and simultaneously for
8 seconds. Both LEDs light up briefly every two seconds.
➔
Unit is reset to its default settings
➔
“Access code” function is switched off
(code is cleared)
➔
A new initialisation and teach-in phase begins
(see chapter 4)
X
Y