User`s manual

BP-002 User's Manual
- 34 -
Table A-4 Pin assignments of the serial interface
Pin Number Signal From Description
2 RXD Host Receive data from Host
3 TXD Printer Sent control code X-ON/X-OFF and data to the Host
8 CTS Printer
“MARK” state means printer is too busy to receive data;
“SPACE” means printer is ready for receiving data.
5 GND — Signal GND
4 DTR Printer Signal terminal is ready
Note: ① “From” means the source where signal comes out.
② Signal level is EIA level.
The default settings in serial connecting way are 9600bps, 8 bits, parity check disabled and 1 stop bit.
BP-002 printer’s serial interface can be connected with the st
andard RS-
232C connector. When
connecting with a PC, the connecting picture is shown as Figure 5-6. While connecting with an IBM PC
or a compatible PC, you can connect the cable as shown in Figure 5-7.
Serial interface connection pictures:
5.2.5 Ethernet Interface
Ethernet interface of 10/100 Base-T can be connected to 10/100M.
Table A-4 Pin assignments of the serial interface
Figure 5-7 BP-002 connecting with 25-Pin PC
Figure 5-6 BP-002 connecting with 9-Pin PC
DTR
CTS
GND
TXD
RXD
DSR
DCD
CTS
RTS
GND
RXD
TXD
4
8
5
3
2
6
1
8
7
5
2
3
Printer 9-Pin connector
Host 9-Pin connector
DTR
CTS
GND
TXD
RXD
DSR
DCD
CTS
RTS
GND
RXD
TXD
4
8
5
3
2
6
8
5
4
7
3
2
Printer 9PIN connector Host 25PIN connector