User`s manual

BP-002 User's Manual
- 26 -
3.5 Setting Slip Stitch (UPDATE and BOOT)
Slip Stitch is used to upgrade printer firmware. In normal working condition, BOOT slip stitch should be
pulling out while UPDATE slip stitch should be plugging into.
Note: Do not change the Slip Stitch without any permission of the factory, or the printer can not
work.
3.6 Online-aptitude Parameter Settings
BP-002 supports the function of online-aptitude parameter settings, which can be set in the PC with
the driver installed in.
The concrete setting steps are shown as follows:
1. Make sure that the computer and the printer are connected with a cable and both the computer and
the printer are turned on, the printer should be in normal working condition as well.
2. Click “Start” → “Settings” → “Printers”.
3. Right click “BP-002”, select “Properties”.
4. Click “Printer settings” in the property page.
When Pulling Out
When Plugging Into
Slip Stitch Cap
Slip Stitch