User`s manual

BP-002 User's Manual
- 17 -
4. Click “Load”, the printer would load the current Wi-Fi setting.
5. Sets the network communication parameters.
Please set the corresponding network communication parameters according to the actual network
circumstances. The detailed information please enquire the network administer.
WLAN type: Select the network mode. Through hotspot, connect the network with router mode,
select “Infrastructure”; Wireless network card communicates with the printer directly,
select “Ad Hoc”; Do not need the Wi-Fi printing function, select “OFF”.
SSID: SSID is the corresponding network name. When “WLAN type” is selected to “Infrastructure”,
network name and the router network name should be the same; when “WLAN type” is
selected to “Ad Hoc”, network name and the wireless network card name should be the same.
Security: Select the security mode of the selected network.
Key: Enter the key of the selected network. When “Security” is selected to “None”, you do not need
to enter key.
6. Set the printer IP parameters.
Please set the corresponding printer IP parameters according to the actual network circumstances.
The detail information please enquire the network administer.
Note: Dynamic assign IP is uncertain, it is easy lead to unsuccessful communication because
of IP mismatching, so we don’t suggest using dynamic assignment.
IP address and subnet mask should obey the assignment rule of the local LAN.
Use DHCP: Select to use dynamic IP assignment or not. When select “Use DHCP”, the IP parameters
would be invalid. Please ensure there it DHCP server in the network firstly, or else the
printer would not achieve the valid IP address. Do not select “Use DHCP”, you should
specify static address.
Local IP: The IP address of printer Wi-Fi interface.
Subnet mask: The subnet mask of printer Wi-Fi interface.
Local port: The local port of the printer Wi-Fi interface. It is suggested using 9100.
Record the printer IP address and port number, the IP address and port number would use in the
Newly-install way or Upgrade-install way in next chapter.
7. Setting remote IP parameters.
The remote IP is a segment of the LAN or the PC IP which communicates with printer.
When filling in IP, such as “192.168.0.1”, PC communicates with printer respectively; when filling in
segment, such as “192.168.0”, the PCs in this segment all can communicate with the printer.
8. After finish setting, click “Save” to save the setting and then restart the printer.
2.8.3 Checking Wi-Fi Parameters
After setting Wi-Fi network parameters, you should check the parameters to ensure the Wi-Fi network
connection is properly.
1. Through “ping” command to check if the printer connects to network or not.
2. When “WLAN type” is select to “Infrastructure”, you could look into the Wi-Fi indicator lights to judge
the connection status.
Indicator Lights Description
Infrastructure Ad Hoc OFF
Connect ON ON BLINK
Disconnect BLINK ON BLINK
Network
Light
Communication