User`s manual

BP-002 User's Manual
- 16 -
SSID
Network name.
The longest network name is 32 characters and there is no space
between characters.
When WLAN type Infrastructure, the network name is the same with the
router’s network name;
When WLAN type Ad Hoc, the network name is the same with the
wireless network card’s network name.
Security Select the security mode.
Key
Enter the corresponding key.
When “Security” is selected to “None”, do not need to enter key.
Use DHCP
Select to use dynamic IP assignment or not. There is no need to change
this parameter normally.
Note: Dynamic IP assignment is uncertain, it is easy lead to
unsuccessful communication because of IP mismatching, so
we don’t suggest using dynamic assignment.
Local IP
IP address of printer Wi-Fi interface.
Note: This IP address should not conflict with other network
devices.
If “Use DHCP” has been selected, then this IP is invalid.
Subnet mask The subnet mask of printer Wi-Fi interface.
Local port The local port of printer Wi-Fi interface. It is suggested using 9100.
Remote IP
The remote IP is a segment of the LAN or the PC IP which communicates
with printer.
When filling in IP, such as “192.168.0.1”, PC is communicate with printer
respectively; When filling in segment, such as “192.168.0”, the PCs in this
segment all can communicate with the printer.
Recover default
Recover the default setting.
After recover the default setting, you should set the Wi-Fi parameters
again.
Save Save the setting parameter. After saving, please reboot the printer.
Press F1 to get help Press F1 to get the help information.
2.8.2 Set Wi-Fi Parameters
Note: 1. You should use the USB interface cable to connect the printer and computer before
configuring Wi-Fi parameters, and run the WiFiConfig software.
2. Configuring Wi-Fi parameters should in the setup mode (besides recover the default
setting).
3. You should make sure the printer is in normal working condition before running the
WiFiConfig software.
The detail parameter configuration instruction and cautions please refer to the Help of WiFiConfig.exe.
Press F1 to pop up the Help instruction when running that software.
1. Connect the printer and the computer with a USB interface cable, and then turn on both the printer
and the computer, run the WiFiConfig software.
2. Check if the corresponding printer model is in the list of Select a printer, if no, please click “Refresh”,
select the corresponding printer model after it appears.
3. Click “Enter setup mode”, it will pop up a Success dialog box when it enters the mode successfully.
After entering setup mode, printer could not receive print data, and you should restart the printer
before printing.