User Manual

42 Using Renamic
Using an External Printer
Prerequisites You can connect an external printer to Renamic under the following electrical
safety conditions:
• With the exception of the wireless connection, after the system has been
installed in the hospital, compliance with the leakage current limit values
according to IEC 60601-1, paragraph 16.6 must be demonstrated.
• The printer must be set up outside the patient environment (at least 1.5 meters
away from the patient). You can use any printer that supports the PCL5 printer
language and is compatible with a generic HP driver.
Configurations In order to ensure electrical safety, it is only permissible to connect an external
printer if one of the following conditions is met for the connection between the
printer and Renamic:
• The printer is Bluetooth-compatible. The connection to Renamic is established
using the accessory Bluetooth adapter (See Equipping the device with a Blue-
tooth adapter, p. 27).
• The printer is powered via the mains supply and is connected to the USB port of
Renamic via an isolating separator (IEC 60601-1, Paragraph 16.5) with a dielec-
tric strength of at least 1.5 kV (e.g. an isolating USB hub model UISOHUB4 by
B&B electronics).
• The printer is supplied directly from the mains by a medical device power
supply. Connect it to the USB port of Renamic.