User Manual

29 Startup
Switching On and Off
Switching the device on The on/off button is located on the back left of the device.
Bild 10: The on/off button is positioned next to the power cord port.
• To switch the device on, press the on/off button once on the pressure point.
• The on/off LED on the front left of the device lights up.
For the position of the on/off LED: refer toPGH compartment, p. 19, item #25.
Startup of the operating
system
After switching the device on, the operating system will boot.
During this time, the device cannot be operated.
Meanwhile, the start screen will also load.
Ready-for-service status,
start screen
After successful booting of the operating system, the screen displays the complete
start screen which indicates the device's ready-for-service status.
Depending on whether a programming head is connected, the device has telemetry
contact to an active implanted device and/or which other ports are occupied, then
the start screen may display additional details.
Bild 11: Start screen after successful booting of the operating system
•Check all displays and signals at all times for correct functionality. If a display
does not function correctly, then look for the cause. If necessary, switch the
device off and then on again.
Note: The device can be switched on in both the working position (screen open)
and in the transport positions (closed).
The on/off LED is visible in both positions.