User Guide

ManualsBrandsBioTel ManualsMonitoring SystemBioTel ART-246 Blood Glucose Monitoring System

Quick Start

Guide

Blood Glucose

Monitoring System

All images are

for reference only

POWER BUTTON

Short-press of power button

turns on/o the screen.

PHYSICAL UP/DOWN, ENTER

buttons can be used to navigate

through menus.

BACK BUTTON

Press of back button returns to the

previous screen except in Test Mode.

HOME BUTTON

Press of home button returns to the

Home screen except in Test Mode.

INFO BUTTON

Press of info button displays a dialog

box with helpful information for the

current screen.

CHARGING PORT

BEFORE YOU START TAKE A BLOOD GLUCOSE TEST

Before ﬁrst use, charge the glucose

meter for at least 6 hours with the

AC charger included in your kit.

Conduct a Control Solution Test per

instructions in Section D.2 of the

BioTel Care BGM® User Manual.

Wash your hands and testing site with

warm water and soap. Dry your hands well.

Clean and disinfect your lancing device

after every use. Clean and disinfect your

meter at least once a week. Please refer

to details in the manual.

Power on and insert a new test strip until

it is fully seated and Apply Blood appears.

Insert a new lancet into the lancing device

and twist o its plastic cap.





IMPORTANT:

The lancing device is intended for single patient use.

Adjust the cap

to your desired

puncture

depth level.

Using your thumb,

push the sliding

button back. You will

hear a click, indicating

that the lancet carrier

is locked into position.





This is a

Touch Screen

ART-246 Rev. 0

TEST STRIP PORT

Summary of content (2 pages)

PAGE 1
® Blood Glucose Monitoring System Quick Start Guide All images are for reference only ART-246 Rev. 0 TEST STRIP PORT This is a Touch Screen POWER BUTTON Short-press of power button turns on/off the screen. PHYSICAL UP/DOWN, ENTER buttons can be used to navigate through menus. BACK BUTTON Press of back button returns to the previous screen except in Test Mode. HOME BUTTON Press of home button returns to the Home screen except in Test Mode.
PAGE 2
BLOOD GLUCOSE TEST CONTINUED  Position the end of the device against the side of the fingertip. VIEW AND ADD LOGS  Select a Reading Tag during or after the countdown. Press the trigger button to actuate the lancet.  Make sure the APPLY BLOOD screen is displayed. Touch the blood drop until the end is filled. After the test strip is filled, the device will display a countdown while calculating the reading. Your test result will appear after the countdown is over.