Service manual

94 User’s Manual—SNAP™ 500 2/1 Printer
Procedure
1. Start with the lowest Heat Level setting from the table below. Enter this combination
in the Supplies section of the PCMate format.
2. Place the printhead contrast knob all the way counter-clockwise.
4. Begin printing. Move the contrast knob clockwise until print quality as acceptable or
you hit the high stop.
5. If you hit the high stop, select the next heat level or maybe skip one and repeat the
procedure until print quality.
6. Be careful at the high heat settings. The thermal transfer ribbon can break if the
temperature is too high.
~XA~XUS0~XW1536~XP4546~XMH4180~XFN~XL1~XS30~XN1~XT203~XN2~XT203~XC01~XX700~
XD300~XGL
CAUTION: For extended print head life and prevent ink
breakage, use the lowest heat level and print contrast
knob setting that produces acceptable print quality.
Heat
Level
Transfer Type code PCMate Transfer Type Setting
Ultra Low
76
2795, TT3111
Low
71
2800, TT3111
Medium Low
161
2895NWT,XC3111
Medium
171
4700TWT, PL1111
Medium High
131
4800TWT, HS1111
High
170
4041THS, HS1111
Ultra High
129
4800NBC, SD1011
