Service manual

User’s Manual—SNAP™ 500 2/1 Printer 17
2.5.2 Mains Disconnect
WARNING: Before connecting and powering on the
printer, you must check to be sure the mains line voltage
is 100-240VAC @ 50-60Hz, single phase.
There are no main fuses on the SNAP 500 printer. The line cord is the printer’s
mains disconnect device.
1. Look at the line voltage level shown on the back of the printer (see Figure 5).
If the mains line voltage for your location is within the range limits, you can
proceed with setting up your printer.
2. If the line voltage does not match the voltage for your location, contact your
local AVERY DENNISON supplier.
• In the U.S.A., call [phone].
• Outside the U.S.A., please contact your local AVERY DENNISON supplier.
WARNING: Some printers require internal changes when
switching the line (mains) voltage from 115V to 230V.
Refer to Appendix 1 for instructions. Failure to follow the
instructions may result in damage to the printer.
CAUTION: If the number in the window DOES NOT match
the AC power line intended to be supplied to the printer,
DO NOT plug in the power cord.
WARNING: Attempting to open the AC power entry with
the AC power cord already inserted will damage the AC
entry.
Figure 5: Right Side of Printer – Rear View

Blank, No Fusing or
Strapping Required


