Owner's Manual

TG31-A7
23
Notices:
Not all types of Intel CPU perform above overclock setting ideally; the difference will be based on the
selected CPU model.
B. Memory Integration Test (M.I.T.)
This function is under “Overclocking Navigator Engine” item.
MIT allows users to test memory compatibilities, and no extra devices or
software are needed.
Step 1
The default setting under this item is “Disabled”; the condition parameter should
be changed to “Enable” to proceed this test.
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Chipset T-Series
vxx.xx (C)Copyright 1985-200x, American Megatren ds, I nc.
Select Scree n
Select Item
Go to S ub Screen
General Help
Save an d Exit
Exit
Enter
F1
F10
ESC
T-Ser ies Settings
WARNI NG: Setting wrong values i n below section s
may cause system to ma lfunction.
===== ====== Automate OverClock System ======== ===
===== ======= Manual OverClock S ystem ========= ===
OverC lock Navigator [Normal]
PCIE Clock By [Auto]
CPU V oltage [Default]
FSB V oltage [Default]
Chips et Voltage [Default]
Memor y Voltage [Default]
DRAM Frequency [Auto]
Confi gure DRAM Timing by SPD [Enabled]
Auto OverClock System [V6-Tech Engine ]
CPU F requency Setting [200]
PCIE Frequency Setting [100]
Integ rated Memory Test [Disabled]
Exit
Opti ons
Disabled
Enabled
↓
BIOS SE TUP UTILITY
Main Advanced PCIPnP Boot Chipset T-Series
vxx.xx (C )Copyright 1985-200x , American Megatrends, Inc.
Select Screen
Select Item
Go to Sub Screen
General Help
Save and Exit
Exit
Enter
F1
F10
ESC
T-Ser ies Settings
WARNI NG: Setting wrong values in below sections
may cause system to malfunction.
===== ====== Automate OverClock System ===========
===== ======= Manual OverClock System ============
OverC lock Navigator [Normal]
PCIE Clock By [Auto]
CPU V oltage [Default]
FSB V oltage [Default]
Chips et Voltage [Default]
Memor y Voltage [Default]
DRAM Frequency [Auto]
Confi gure DR AM Timing by SPD [Ena bled]
Auto OverClock System [V6-Tech Engine]
CPU F requency Setting [200]
PCIE Frequency Setting [100]
Integ rated Memory Test [Enabled]
Exit
Options
Disabled
Enabled
Step 2
Save and Exit from CMOS setup and reboot the system to activate this test.
Run this test for 5 minutes (minimum) to ensure the memory stability.
Step 3
When the process is done, change the setting back from “Enable” to “Disable”
to complete the test.