Owner's Manual

TForce4 / TForce4 Ultra

Parallel Port Mo de

The default value is SPP.

The Choices:

SPP(default) Usin g P aralle l port as Standard P rinter P ort.

EPP Usin g Paralle l P ort as Enhanced P aralle l Port.

ECP Using Parallel port as Extended Capabilities Port.

ECP+EPP Using P aralle l port as ECP & EPP mode.

ECP Mode Use DMA

Select a DMA Channel for the port.

The Choices: 3 (default), 1.

IDE HDD Block Mode

Block mode is also called block transfer, multiple commands, or multiple sector

read / write. If your IDE hard drive supports block mode (most new drives do),

select Enabled for automatic detection of the optimal number of block mode (most

new drives do), select Enabled for automatic detection of the optimal number of

block read / write per sector where the drive can support.

The Choices: Enabled (default), Disabled.