User`s manual

Biostar T
Biostar TBiostar T
Biostar T-
--
-Series
SeriesSeries
Series TF
TFTF
TForce4
orce4orce4
orce4 SLI
SLI SLI
SLI
User’s Manual
5
2.3 PERIPHERALS
A. Card and I/O Slots:
Floppy Disk Connector: FDD1
The motherboard provides a standard floppy disk connector that supports
360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector
supports the provided floppy drive ribbon cables.
1
2
33
34
Hard Disk Connectors: IDE1/IDE2
The motherboard has two 32-bit Enhanced PCI IDE Controllers that provide
PIO Mode 0~5, Bus Master, and Ultra DMA 33/66/100/133 functionality. It
has two HDD connectors IDE1 (primary) and IDE2 (secondary). The IDE
connectors can connect a master and a slave drive, so you can connect up
to four hard disk drives. The first hard drive should always be connected to
IDE1.
12
39 40
IDE2
IDE1
Peripheral Component Interconnect Slots: PCI1~PCI3
This motherboard is equipped with 3 standard PCI slots. PCI stands for
Peripheral Component Interconnect, and it is a bus standard for expansion
cards. This PCI slot is designated as 32 bits.
PCI1
PCI2
PCI3
PCI-Express Slots: PEX16-1/PEX16-2/PEX1-1/PEX1-2
PEX16-1 (Normal Mode):
- PCI Express 1.0a compliant.
- Maximum bandwidth is up to 4GB/s per direction.
PEX16-1/PEX1-1/PEX1-2 (Normal Mode):
- PCI Express 1.0a compliant.
- Maximum bandwidth is up to 250MB/s per direction.
PEX16-1/PEX16-2 (SLI Mode):
- PCI Express 1.0a compliant.
- Maximum bandwidth is up to 2GB/s per direction.
PEX16-1
PEX1-1
PEX1-2
PEX16-2