User`s manual

Motherboard Manual
28
Notices:
1. Not all types of AMD CPU perform above overclock setting ideally; the difference will be based
on the selected CPU model.
B. Memory Integration Test (M.I.T.)
This function is under “Overclocking Navigator Engine” item.
MIT allows users to test memory compatibilities, and no extra devices or
software are needed.
Step 1
The default setting under this item is “Disabled”; the condition parameter should
be changed to “Enable” to proceed this test.
BIOS SE TUP UTILITY
Main Advan ced PCIPnP Boot Chipset T-Series
vxx.xx (C )Copyrigh t 1985-200x, American Megatrends, Inc .
Select Screen
Select Item
Go to Sub Screen
General Help
Save and Exit
Exit
Enter
F1
F10
ESC
T-Ser ies Settings
WARNI NG: Setting w rong values in below sections
may cause system to malfunction.
===== ====== Automate O verClock System ===========
===== ======= Manua l OverClock System ============
OverC lock Navigato r [Normal]
Auto OverClock Sys tem [V6-Tech Engine]
CPU F requency, MHz [200]
z
> Ove r-Voltage Con figuration
> DRA M Timing Conf iguration
> Spread Spectrum Configu ration
Proce ssor Frequenc y Multiplier [Auto]
SB to K8(CPU) Freq Auto [Enabled]
SB to K8(CPU) Link Width [16 16 ]
Memor y Clock Mode [Auto]
MCP P CI-Express Fr equency, MH [100]
Integ rated Memory Test [Disabled]
Exit
Options
Normal
Automate OverClock
Manual OverClock
↓
BIOS SE TUP UTILITY
Main Advan ced PCIPnP Boot Chipset T-Series
vxx.xx (C )Copyrigh t 1985-200x, American Megatrends, Inc .
Select Screen
Select Item
Go to Sub Screen
General Help
Save and Exit
Exit
Enter
F1
F10
ESC
T-Ser ies Settings
WARNI NG: Setting w rong values in below sections
may cause system to malfunction.
===== ====== Automate O verClock System ===========
===== ======= Manua l OverClock System ============
OverC lock Navigato r [Normal]
Auto OverClock Sys tem [V6-Tech Engine]
CPU F requency, MHz [200]
z
> Ove r-Voltage Con figuration
> DRA M Timing Conf iguration
> Spread Spectrum Configu ration
Proce ssor Frequenc y Multiplier [Auto]
SB to K8(CPU) Freq Auto [Enabled]
SB to K8(CPU) Link Width [16 16 ]
Memor y Clock Mode [Auto]
MCP P CI-Express Fr equency, MH [100]
Integ rated Memory Test [Enabled]
Exit
Options
Normal
Automate OverClock
Manual OverClock
Step 2
Save and Exit from CMOS setup and reboot the system to activate this test.
Run this test for 5 minutes (minimum) to ensure the memory stability.
Step 3
When the process is done, change the setting back from “Enable” to “Disable”
to complete the test.