User`s manual

(14) Power Source Selection for USB: JUSBV1/ JUSBV2/

JUSBV3 (does not support on version 7.x)

JUSBV1/JUSBV2/

JUSBV3

Assignment Description

1 3

Pin 1-2 close

+5V

JUSBV1: 5V for USB located at the

JUSB1 connector port

JUSBV2: 5V for USB located at the

JUSBLAN1 connector port

JUSBV3: 5V for USB located at the

JUSB3/4 connector ports

1 3

Pin 2-3 close

+5V Standby

Voltage

JUSBV1: JUSB1 port powered with

standby voltage of 5V

JUSBV2: JUSBLAN1 port powered with

standby voltage of 5V

JUSBV3: JUSB3/4 port powered with

standby voltage of 5V

Note: 1. In order to support this function “Power-on system via USB device”,

“JUSBV1/ JUSBV2/ JUSBV3” jumper cap should be placed on pin 2-3

respectively.

2. If you are under S3 mode, we recommend you to select +5V

Standby Voltage.

(15) Clear CMOS Jumper: JCMOS1

JCMOS1 Assignment

Pin 1-2 Close

Normal Operation (default)

Pin 2-3 Close

Clear CMOS Data

The following procedures are for resetting the

BIOS password. It is important to follow these

instructions closely.